I had to turn down my settings quite a bit to have somewhat acceptable fps in high havoc, but during my settings purge i turned down a setting that makes the fire and gas visuals kinda hard to see, so now i keep taking damage because i cant quite tell where the edge of a fire or gas patch is.
I cant really figure out which setting actually affects these visuals and was hoping someone here knew which setting it could be.
Probably More Graphic Options mod and you want to do things with the particle capacity multiplier slider, that is setting it back to 1.00 because even going down 0.99 has seriously adverse effects on particle effects visibility.
I would further suggest to wait with tweaks and attempts at optimization after the hotfix (for a hotfix) is released, right now the game performance is all over the place and most of it outside players influence!
I use the mod. Don’t change “Particles Capacity Multiplier”, leave it at 1. If you change it, even to a minimum, fire and gas will be invinsible. I recommend setting mesh quality to 0.2, since (at least on my end) plenty of stuff just dissappears from my sight, like props just become invinsible.